tel. +44 1977 683665
http://www.milinst.com
Alex by David L Buckley - September 1998
| Back to Section Index | Previous | Next |
Mounting the Eyes
To put the eyes on the head you will need the Eye-link wire (part-16), the Eyes-push-rod (part-18), and six lengths of sleeving.
63 
Push an eyeball assembly onto an eye-pivot, don't force it on, remember the LED wires, just wiggle it about and the pivot-wire should just slide past the wires. Put one end of the Eye-link through the hole nearest the eye and fasten it on with a length of sleeving.
64 
65 
66 
Now do the same for the other side.
67 
68 
Fasten one end of the Eye-push-rod into a large servo-disc.
69 
Plug the lead for the Eye-servo onto the connector for channel-2, centre the servo as before and place the disc in position. Put the free end of the push-rod into the hole in the right-hand eye-plate and fasten with a length of sleeving.
70 
71 
Push the eyes all the way up the pivot wires and fasten in place with sleeving.
72 
73 
Move the Position-control and check that the eyes move from side to side properly and are centred when the control is centred.
Fasten on the disk with its screw.
| Top | Top | |
| Back to Section Index | Previous | Next |